Weider 190 T Bench User Manual - page 7
3. Attach the Front Leg (8) to the Frame (2) with
two M8 x 43mm Bolts (39), four M8 Washers
(16), and two M8 Locknuts (17); do not tighten
the Locknuts yet.
4. Attach the Frame (2) to the Crossbar (3) with
three M8 x 55mm Bolts (18), two M8 Washers
(16), and three M8 Locknuts (17); do not tighten
the Locknuts yet.
5. Apply some of the included grease to an M10 x
63mm Bolt (32).
Attach the Leg Lever (4) to the Front Leg (8)
with the M10 x 63mm Bolt (32) and an M10
Locknut (33). Do not overtighten the
Locknut; the Leg Lever must pivot easily.
3
17
2
39
16
16
8
16
4
2
3
17
17
18
18
16
5
33
4
Grease
32
8
7
6. Insert a Pad Tube (10) into a hole in the Leg
Lever (4). Slide two Foam Pads (23) onto the
Pad Tube.
Attach the other Pad Tube (10) and two
Foam Pads (23) in the same way.
10
10
4
23
23
23
23
6