1. DL manuals
  2. Weider
  3. Other
  4. 8507
  5. User Manual

Weider 8507 User Manual

Other manuals for 8507: User Manual, User Manual
Manual is about: User Manual

Summary of 8507

  • Page 1

    User's manual questions? As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee you complete satisfaction through our customer service department. Please call: 0345-089009 or write: ...

  • Page 2

    23 2 table of contents important precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 before you begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

  • Page 3

    3 22 before you begin assembled dimensions: height: 77 in. Width: 39 in. Length: 48 in. Foot plate low pulley station high pulley station lat bar leg lever arms weight stack backrest weight pin weight stack lock cable diagrams the cable diagrams below show the proper routing of the short cable (23) ...

  • Page 4

    4 assembly 39 56 21 58 15 5 89 89 15 15 78 78 21 88 71 4 19 1 27 34 34 32 34 29 3 33 7 30 10 28 34 32 36 13 38 90 18 40 14 23 87 8 22 16 15 3 3 8 3 5 9 26 88 42 41 10 43 25 79 80 85 84 83 45 44 8 33 49 51 47 8 3 54 55 46 9 70 55 54 3 8 49 47 33 45 44 51 9 70 46 44 53 53 44 44 49 52 60 49 57 8 3 3 11...

  • Page 5

    5 3. Slide six weights (25) onto the weight guides (72). Be sure that all of the weights are turned so the pin grooves are on the indicated side. 4. Press the 1 1/4” square inner cap (57) into the front upright (42). Attach the 1” plastic stop (64) to the centre hole in the stop bracket (63) with a ...

  • Page 6

    6 5. Press the weight tube bumper (79) into the end of the weight tube (80). Slide the top weight (77) onto the weight tube. Be sure that the pins on the weight tube are resting in the pin grooves under the top weight. Locate the short cable (23). Attach the short cable to the weight tube (80) with ...

  • Page 7

    18 7 8. Attach the upper ends of the weight guides (72) to the top frame (67) with the 5/16” x 6” bolt (74), two 1/2” x 3/4” spacers (73), and a 5/16” nylon locknut (3). Tighten all nylon locknuts used in steps 4 through 8. 9. Press two 1 3/4” square inner caps (44), two 1 1/2” square inner caps (32...

  • Page 8

    17 attaching and removing the seat set the bracket on the seat frame (36) on the indicated pin on the front upright (42). Attach the seat frame to the front upright with the 5/16” x 2 3/4” carriage bolt (14) and seat knob (40). For some exercises, the seat (13) must be removed. First, make sure that...

  • Page 9

    16 adjustment the instructions below describe how each part of the home gym system can be adjusted. Refer to the exercise guide accompanying this user's manual to see how the home gym system should be set up for each exercise. Important: when attaching the lat bar or nylon strap, make sure that the ...

  • Page 10

    15 29. Slide a handgrip (12) onto each end of the lat bar (85). 29 85 12 12 30. Make sure that all parts are properly tightened. The use of all remaining parts will be explained in adjust- ment, beginning on page 16 of this manual. Before using the home gym system, pull each cable a few times to mak...

  • Page 11

    14 26. Press a 1 1/2” square inner cap (32) into the leg lever (29). Attach the 5/16” x 2” eyebolt (62) to the leg lever (29) with a 5/16” flat washer (8) and a 5/16” nylon locknut (3). Lubricate a 5/16” x 2 1/4” bolt (33). Attach the leg lever (29) to the seat frame (36) with the bolt and a 5/16” n...

  • Page 12

    13 23. Attach the 5/16” x 3 1/2” bolt (87), two 5/16” flat washers (8), the 1” metal spacer (22), and a 5/16” nylon locknut (3) to the front upright as shown. Wrap the short cable (23) around a 3 1/2” pulley (15). Attach the pulley to the front upright (42) with a 3/8” x 3 1/2” bolt (16), a 3/8” was...

  • Page 13

    1" round inner cap (49) 1" round cover cap (55) 3/4" round inner cap (34) 5/16" x 2" eyebolt (62) 1 1/4" square inner cap (57) 1 1/2" square inner cap (32) 1 3/4" square inner cap (44) 2" square inner cap (27) 2" square outer cap (88) wesy87080 r0498a this chart is provided to help you identify the ...

  • Page 14

    1/2" x 3/8" spacer (51) 5/16" nylon locknut (3) 1/4" flat washer (10) 5/16" flat washer (8) 1" retainer (54) 3/8" flat washer (9) 5/16" jam nut (2) 1" plastic stop (64) 1/4" nylon locknut (7) 1/2" x 1/2" spacer (65) 3/8" nylon locknut (21) 1/2" x 3/4" spacer (73) 1/4" nylon jam nut (86) 3/8" nylon j...