Weider 8507 User Manual - page 7
18
7
8.
Attach the upper ends of the Weight Guides (72) to
the Top Frame (67) with the 5/16” x 6” Bolt (74), two
1/2” x 3/4” Spacers (73), and a 5/16” Nylon Locknut
(3).
Tighten all Nylon Locknuts used in steps 4
through 8.
9.
Press two 1 3/4” Square Inner Caps (44), two 1 1/2”
Square Inner Caps (32), and two 1” Round Inner
Caps (49) into the Arm Frame (52).
10. Lubricate the upper axle on the Arm Frame (52).
Hold the axle between the two Arm Frame
Bushings (68). Set the Arm Frame Bushings and
the Arm Frame on the welded plate on the Top
Frame (67). Make sure that the Arm Frame is
turned so the bracket is on the side shown.
Place the Arm Frame Bracket (69) over the Arm
Frame Bushings. Attach the Arm Frame Bracket to
the Top Frame with four 1/4” x 1/2” Screws (31) and
1/4” Nylon Jam Nuts (86).
8
9
10
ATTACHING THE LAT BAR OR NYLON STRAP TO
THE LOW PULLEY STATION
Attach the Lat Bar (85) to the Short Cable (23) with a
Cable Clip (83). For some exercises, the Chain (84)
should be attached between the Lat Bar and the Short
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Short Cable so
the Lat Bar is in the correct starting position for
the exercise to be performed.
The Nylon Strap (39) can be attached in the same
manner.
LOCKING THE WEIGHT STACK
When the home gym system is not in use, the Lock
Pin (20) and Lock (59) should be attached. Insert the
Lock Pin through a Weight Guide (72). Attach the
Lock to the Lock Pin.
39
85
23
83
84
83
20
59
72
67
74
3
73
69
68
Lubricate
67
31
86
Bracket
52
49
52
32
44
72