Weider Cobra 1000 User Manual - page 5
12
5
2.
Press a 1 1/2” Square Inner Cap (50) into the
Right Stabiliser (47). Attach a Foot Plate (49) to
the Right Stabiliser with two 5/16” x 2” Bolts (48),
two 5/16” Washers (20), and two 5/16” Nylon Jam
Nuts (5). Note: The large holes of both Stabilisers
must be on top.
Assemble the Left Stabiliser (46) in the same
manner.
Attach the Left and Right Stabilisers (46, 47) to
the Base (45) with two 5/16” x 2 3/4” Bolts (29)
and two 5/16” Nylon Locknuts (1).
3.
Insert the Weight Guides (38) into the indicated
holes in the Left and Right Stabilisers (46, 47).
Be sure that the ends of the Weight Guides
with two sets of drilled holes are at the top, as
shown.
Attach the Weight Guides (38) to the Left and
Right Stabilisers (46, 47) with 5/16” x 2” Bolts
(48) and 5/16” Nylon Locknuts (1) as shown.
Slide a Weight Guide Sleeve (57), a 1” Washer
(43) and a Weight Bumper (56) onto each Weight
Guide (38). Slide nine Weights (51) onto the
Weight Guides. Be sure that the Weights are
turned so that the pin grooves are facing the
Top Frame (42).
Press the Weight Tube Endcap (59) into the indi-
cated end of the Weight Tube (54). Slide the
Weight Tube into the stack of Weights (51). The
pin on the Weight Tube must be in the pin groove
in the top Weight.
Slide the remaining Weight (51) onto the Weight
Guides (38) and the Weight Tube (54). Be sure
that the Weight is turned so that the pin
groove is facing the Top Frame (42).
4.
Attach the Weight Tube Guide (55) and the indi-
cated end of the Long Cable (18) to the Weight
Tube (54) with a 5/16” x 1 1/2” Bolt (21) and a
5/16” Nylon Locknut (1).
3
4
49
46
47
45
5
1
50
20
29
48
Two Holes
51
42
38
55
54
57
57
56
43
56
43
Pin Groove
Pin Groove
46
47
48
1
51
21
1
18
54
59
2
Large
Holes
FOLDING THE BACKREST FOR STORAGE
First, lock the Press Arm Lever (8) in place at the top
of the Weight Guides (see LOCKING THE PRESS
ARM LEVER on page 11).
Lift the Backrest (27) up and lean it against the
Weight Guides (38). Wrap the Short Cable (71)
around the Backrest Frame (28) and one of the
Weight Guides. Secure the Cable with the Cable Clip
(72).
27
38
8
71
72
28