Wood Heating Solutions NC-30 Installation And Operation Manual - page 17
Page 17 / 28
shutdown after the time has expired.
Child Lock
Press the up & down arrows together for 3 seconds to lock and unlock the controller.
Diagnostic Mode (only when not running)
Press and hold “set” to enter the programming menu and scroll down to “Diagnostic”. Press set and the diagnostic screen
will be displayed. This will allow each component (Igniter, Room Blower, Exhaust Blower, Auger Motor) to be run
manually and show whether the hopper lid, vacuum and exhaust temperature switches are closed. Move the arrow to the
component desired and press “set” to highlight it. Press “Up” or “Down” to toggle the component on or off (a filled-in circle
means on or closed)
. Adjusting the “Stalls” from 1-5 will cause a component to run at its programmed rate as if it were in
heating mode.
NEVER TURN ON THE IGNITER (FIRE) WITHOUT THE EXHAUST BLOWER RUNNING AND THE DOOR AND ASH
PAN CLOSED OR IT CAN OVERHEAT. NEVER LEAVE THE CONTROLLER IN DIAGNOSTIC MODE.
NTC1 is the Exhaust Temperature Sensor, NTC2 is the High Temperature Sensor (80C is normal, 99C is alarm condition)
WARNING: TURNING THE STOVE OFF DOES NOT DISCONNECT ALL POWER FROM THE UNIT.
DO NOT TURN OFF THE UNIT BY DISCONNECTING THE ELECTRICAL POWER TO THE UNIT. THIS WILL
CAUSE THE UNIT TO MISS THE PROPER SHUTDOWN CYCLE, CAUSING THE RELEASE OF SMOKE INTO THE
HOUSE AND OVERHEATING OF THE STOVE.
Refueling the Unit
To refuel, open the hopper and add desired amount of pellets. The auger motor will automatically stop when the hopper
is opened. WARNING: THE HOPPER LID AND OTHER SURFACES MAY BE HOT. BE CAREFUL AND WEAR HAND
PROTECTION. NEVER PLACE YOUR HAND NEAR THE AUGER WHILE THE STOVE IS OPERATING. DO NOT
OVERLOAD.
Adjusting Airflow
Due to different fuel densities and sizes, pellet feed rates may vary. This may require the air intake damper setting
(located where the intake air pipe meets the combustion chamber) to be adjusted. To increase airflow, pull on the tab
located on the left hinged panel and push in to decrease airflow. Increase airflow if the flame is orange and lazy, and
decrease airflow if pellet coals are being thrown out of the burn pot. The adjustment range of the damper must not be
altered for any reason. Since
Nature’s Comfort has no control over the quality of pellets that are use, the installation
or heating demands, we assume no liability for y
our choice in wood pellets or the stove’s performance. Store pellets at
least
36” (1 m) away from the pellet stove in a dry place.
WARNING: DO NOT OVERFIRE THE STOVE OR USE HIGHLY VOLATILE FUELS. THIS MAY CAUSE SERIOUS
DAMAGE TO YOUR STOVE AND WILL VOID YOUR WARRANTY. IT MAY ALSO CREATE A FIRE HAZARD IN
YOUR HOME.