Wood’s AD series User Manual - page 6
6
7
Thank you
Thank you for choosing a Wood’s
product. You are one of more than
300.000 people who have chosen
Wood’s to prevent damages from
excessive moisture and mould and
to clean the household air. Origi-
nating in Canada in 1950, Wood’s
has more than 60 years experience
of developing and manufacturing
dehumidifiers and air cleaners. When
choosing a Wood’s product you’ll get
a unit with great quality, high capacity
and that will extract the most litres
per consumed kWh.
Wood’s AD-series
The Wood’s AD-series are unique
air treatment products that combine
Wood’s high capacity and reliable de-
humidification with a unique filtration
system that clean the household air.
The energy efficient compressor
dehumidifier remove excess moistu-
re from the air and releases dry air
in the room. At the same time, the
Swedish made Active ION HEPA fil-
ters remove harmful particles - crea-
ting a healthier indoor environment.
1. Security warnings
Please read the security warnings
carefully before installing and using
the appliance. If the security regula-
tions are not followed, it may void the
product warranty and even present a
fire hazard:
• Unplug the unit from its power
supply before cleaning, storage or
maintenance of its filter.
• This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of expe-
rience and knowledge, unless they
have been given supervision or
instructions concerning use of the
appliance by a person responsible
for their safety.
• The appliance shall be installed
in accordance with national wiring
regulations.
• If the supply cord is damaged,
it must be replaced by the ma-
nufacturer, its service agent or
similarly qualified persons in order
to avoid a hazard.
• Always keep a safe distance from
water sources.
• The appliance is a heat source. It
is very important that the applian-
ce isn’t covered and that it is kept
away from inflammable materials
and other heat sources.
• Do not put fingers or other
objects into air inlet or air outlet.
• Do not stand on the machine.
• Do not cover the appliance.
• Do not to alter or reconstruct the
appliance or its power cable in any
way.
• Always drain the water
according to the instructions.
• The compressor in the unit is filled
with a freon free refrigerant. If there
is a leakage on the refrigerant
system you should stop using the
appliance and contact your retailer.
• Do not use the appliance without its
air filter.
• The unit generates water, always
keep a safe distance from materials
sensitive to water damage, such as
wooden floors.
2. Installation and
placement
Wood’s products are easy to move
around, but bare in mind the fol-
lowing.
• The appliance should not be placed
near radiators or other heat sour-
ces or exposed to direct sunlight,
as it will reduce its performance.
• Keep at least 25 cm distance from
walls and other obstructions to
maximize the air flow.
• For optimum performance, place
the appliance in the middle of the
room.
• Make sure that the air flow from the
inlet and outlet isn’t blocked
Installation:
1. Place the appliance on a flat and
solid ground, preferably in the middle
of the room.
2. Close all windows and ventilators
in the room. Otherwise, moist and
dirty air from the outside will continue
to flow into the room.
3. Connect the appliance to a groun-
ded power outlet.
If the appliance is transported
horizontally, oil may have run out of
the compressor and into the closed
piping system. In such a case, let
the appliance stand for a few
hours before being used. It is very
important that the oil runs back into
the compressor, otherwise it may be
seriously damaged.
3. Using the AD-series
Humidistat controlled
The unit will run only when the
ambient humidity exceeds your set
value.
Pollution detection
The unit will detect pollution in the
household air and start air cleaning
automatically.
Automatic restart
In the event of a power failure, the
unit will continue to work according to
your latest settings once the power
returns.
Automatic defrost
When running in dehumidification
mode, the unit will automatically de-
frost when needed. When defrosting,
the defrost icon is illuminated and all
buttons are locked. The dehumidifi-
cation will restart when the defrost is
completed.
English