Woodbridge Fireplace Inc DVI 1000 Installation And Operating Instructions Manual - page 4
4
48D0139
5
IMPORTANT SAFETY INFORMATION
Continued from page 3
12. Do not use this insert to cook food or burn paper or other
objects.
13. Never place anything on top of insert.
14. Do not use any solid fuels (wood, coal, paper, cardboard,
etc.) in this insert. Use only the gas type indicated on
rating plate.
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70
, or the Canadian Electrical Code,
CSA C22.1.
17. Do not use insert if any part has been exposed to or
under water. Immediately call a qualified service techni-
cian to inspect the appliance and to replace any part of
the control system and/or any gas control that has been
under water.
18. Do not operate the appliance if any log is broken.
20. Cutting any sheet-metal parts of the fireplace, in which
the gas insert is to be installed, is PROHIBITED.
21. A gas appliance must not be connected to a chimney
flue serving a separate solid-fuel burning appliance.
and others may be susceptible to accidental contact burns.
duals in the house. To restrict access to a fireplace or stove,
children, and other at risk individuals out of the room and
the same room as the appliance. Toddlers, young children,
install an adjustable safety gate to keep toddlers, young
away from hot surfaces.
26. Children and adults should be alerted to the hazards of
high surface temperature and should stay away to avoid
burns or clothing ignition.
29. Young children should be carefully supervised when they in
IMPORTANT:Safety Screen must be in place when the fireplace is in operation. If
the barrier becomes damaged, the barrier shall be replaced with the manufacturer's
barrier for this appliance. Any safety screen, guard, or barrier removed for servicing
the appliance, must be replaced prior to operating the appliance.
WARNING: A barrier (safety screen) designed to reduce the risk of burns from the
hot viewing glass is provided with this appliance and shall be installed for the
protection of children and other at-risk individuals.
SAFETY SCREEN INFORMATION:
A physical barrier is recommended if there are at risk indivi-
28. Installation and repair should be done by a qualified ser-
vice person. The appliance should be inspected
before use and at least annually by a professional service
person. More frequent cleaning may be required due to
excessive lint from carpeting, bedding material, etc. It is
imperative that control compartments, burners, and
circulating air passageways of the appliance be kept
clean.
25. Refractory glass doors, screen rails, screen mesh and log
grates can be removed from the fireplace before
installing the gas fireplace insert.
27. Handle glass door with care to avoid striking or scrat-
ching it on hard objects. WARNING: Do not operate
appliance with the glass front removed, cracked or
broken. Replacement of the glass should be done by a
licensed or qualified service person.
19. WARNING:
Do not operate the appliance with glass
door removed. Replacement of the glass should be
doneby a licensed or qualified service person.
may be drilled through the lower sides or bottom of the
firebox in a proper workmanship like manner. This
access hole must be plugged with non-combustible
insulation after the gas supply line has been installed.
22. If the factory-built fireplace has no gas access hole(s)
provided, an access hole of 1.5 inch (37 mm) or less
16. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and proper
operation. Trim panels or surrounds shall not seal
ventilation openings in the fireplace.
23. The fireplace flue damper can be fully blocked open or
removed for installation of the gas fireplace insert.
24. The fireplace and fireplace chimney must be clean
andin good working order and constructed of
non-combustible materials. The chimney clearouts
must fit properly.