Woodstock Shop Fox W1690 Instruction Manual - Flush Mount

MAINTENANCE

-12-

Figure 9. Typical unacceptable fasteners.

Figure 10. Flange bracket mounting holes and lip.

Figure 11. Flange correctly installed under lip.

You can install the air filter unit in a confined

shop by mounting it flush to a ceiling, wall, or

table using the flange mounts.

To install the air cleaner for flush mount

operation, do these steps:

1. Locate the applicable load bearing studs or

supports in the wall or ceiling, and mark the

air cleaner unit bolt pattern on the wall or

ceiling (17

1

⁄

4

" from left-to-right and 31" from

front-to-rear).

2. Drill the bolt pattern to accept at least 

1

⁄

4

"

shank lag bolts for studs, or use 

1

⁄

4

" nuts,

bolts, and washers for mounting to supports.

3. Position the flange bracket under the air

cleaner unit lip at the mounting hole location.

See  Figure 10. For permanent table top

mounting, use the lower-lip holes.

4. Install the flat washers and the hex bolts to

secure the flange brackets to the unit. See

Figure 11.

5. Repeat  Steps 3 and 4 for the other three

flange brackets. 

6. With the help of an assistant, position the air

cleaner on the wall or ceiling, and screw or

bolt the unit in place. 

Flush Mount

ONLY mount the air cleaner unit to load bearing

supports, wall studs, or table that can hold at

least 100 lbs. DO NOT mount the unit to sheet

rock walls, pressboard, paneling, or honeycomb

wall panels with expansion-type fasteners like

the ones shown in Figure 10. The fasteners can

tear out and the air cleaner can fall. Ignoring this

warning can result in severe injury or death.

Get lifting assistance

before  installation. At 55

pounds, the Model W1690

air cleaner is a heavy load. 

Mounting

holes

Flange bracket

mounted under lip

Lip