1. DL manuals
  2. Worcester
  3. Inverter
  4. CS 200
  5. Installation Instructions Manual

Worcester CS 200 Installation Instructions Manual

Manual is about: Solar controller

Summary of CS 200

  • Page 1

    6720830475 (2015/06) installation instructions for installers solar controller cs 200 0010007286-001.

  • Page 2

    2 table of contents cs 200 – 6720830475 (2015/06) table of contents 1 key to symbols and safety instructions . . . . . . . . . . . . 3 1.1 explanation of symbols . . . . . . . . . . . . . . . . . . . . . . 3 1.2 general safety instructions . . . . . . . . . . . . . . . . . . . 3 2 product descriptio...

  • Page 3

    3 key to symbols and safety instructions cs 200 – 6720830475 (2015/06) 1 key to symbols and safety instructions 1.1 explanation of symbols warning symbols keywords at the start of a warning indicate the type and seriousness of the ensuing risk if measures to prevent the risk are not taken. The follo...

  • Page 4

    4 product description cs 200 – 6720830475 (2015/06) ▶ due to the additional functions, e.G. Dhw heating or pump anti-seizure protection, the system should always be left on. ▶ correct any faults immediately. 2 product description 2.1 product description • the cs 200 must be used in conjunction with ...

  • Page 5

    5 installation cs 200 – 6720830475 (2015/06) table 2 technical specifications 2.6 temperature sensor characteristics when measuring temperature sensors, observe the following requirements: • isolate the system before measuring. • measure the resistance at the cable ends. • the resistance values repr...

  • Page 6

    6 installation cs 200 – 6720830475 (2015/06) fig. 3 installation of wall-mounting plate bus bus interface connection 3.4 electrical connection power is supplied to the solar controller via the bus cable. The wires are insensitive to polarity. If the maximum total length of the bus interfaces between...

  • Page 7

    7 basic principles of operation cs 200 – 6720830475 (2015/06) ▶ remove the solar controller by lifting upward. Fig. 5 removing the solar controller 4 basic principles of operation 4.1 overview of the control elements if the display lighting is dimmed, any button press activates the light. The user t...

  • Page 8

    8 commissioning cs 200 – 6720830475 (2015/06) 4.3 operating the service menu closing and opening the service menu opening the service menu ▶ hold the menu key until the service menu is displayed. Closing the service menu ▶ if no sub-menu is open, press the back key to switch to the standard display....

  • Page 9

    9 commissioning cs 200 – 6720830475 (2015/06) 5. Fill and vent the system. 6. Commissioning the cs 200 solar controller (  chapter 5.2, page 9) 7. Commissioning the system with the solar controller (  chapter 5.3, page 9) 8. Check and, if necessary, adjust the settings in the service menu of the c...

  • Page 10

    10 shutdown / switching off cs 200 – 6720830475 (2015/06) table 6 settings in the commissioning menu 5.4 additional settings at commissioning some settings are only available if the system is designed and configured accordingly. For more details refer to the ms 100/ ms 200 technical documentation. ▶...

  • Page 11

    11 service menu cs 200 – 6720830475 (2015/06) – speed ctrl. Solar pump...2 – gross collector area 1 – 2 – type collector array 1 – climate zone – start solar thermal system – max. Dhw temp. – dhw temp. – circulation time – circulation pulse – max. Dhw temp. Solar settings – change solar configuratio...

  • Page 12

    12 service menu cs 200 – 6720830475 (2015/06) 7.1 solar system settings fig. 8 solar settings menu if a solar system with extended functionality is installed, corresponding menus and menu items become active. The menus of the solar system are described in detail in the operating instructions of the ...

  • Page 14

    14 troubleshooting cs 200 – 6720830475 (2015/06) if daily heat-up is activated: • the entire dhw volume is heated up daily to the temperature that has been set for the daily heat-up. This function is not performed, if the domestic hot water has already reached the set temperature within the last 12 ...

  • Page 15

    15 environmental protection and disposal cs 200 – 6720830475 (2015/06) table 14 fault displays with fault code a51 10 environmental protection and disposal environmental protection is a key commitment of the bosch group. Quality of products, efficiency and environmental protection are equally import...

  • Page 16

    Worcester, bosch group cotswold way, warndon, worcester wr4 9sw. Tel. 0330 123 9559 worcester, bosch group is a brand name of bosch thermotechnology ltd. Worcester-bosch.Co.Uk 6720830475 worcester, bosch group: technical support: 0330 123 3366 appointments: 0330 123 9339 spares: 0330 123 9779 litera...