Work Pro W4 PRO DMX User Manual - 2. Operation Guide
I N
2. Operation Guide
2. Operation Guide
2.2 DMX Mode
2.1 Mode Select
2.2 DMX Mode
5
6
Press and hold down F button first, tap the
Signal Select button causing the Segment
Display shows "IN", DMX LED lights indicating
DMX mode is active, this unit serves as a 4
channel DMX dimmer pack.
While holding down F button, tap Signal
Select button, when the Segment Display
shows"OUT", Master LED lights indicating
Master mode is active, this unit serves as a
4 channel DMX chaser when linkup use.
1. Tap the channel button, the corresponding
channel LED blinks indicating your selection
and the Segment Display shows the DMX
address of last time.
2. Tap the Up/Down button to select your desired
DMX address from 001 to 512.
3. Once you've set the DMX address, tap the
channel button a second time to store your
setting into memory.
4. Continue steps 1-3 until you've set all 4
channels.
When the Segment Display shows "IN" and the DMX LED lights, this unit serves
as a 4 channel DMX dimmer pack. The DMX Signal LED blinks when DMX signal
is present.
025
2.3 Master Mode
2.3.1 Chase Mode
When the Segment Display shows "OUT" and the
Master LED lights, this unit serves as a 4 channel
DMX chaser.
Keep pressing F button, tap Mode button several
times to select chase mode from Manual Dimmer/
Manual Program/Auto Program/Auto Sound/Prog.
Sound/Hold Sound, corresponding LED lights
indicating your selection.
0 0
025