World Tech Toys 33805 Instruction Manual - page 2
BATTERY INSTALLATION (OPTIONAL)
DART BLASTER ASSEMBLY
To assemble dart blaster, insert bow pieces into main body of
blaster by pushing down on release slide (1.) and lining up tabs
with body as you push pieces in until secure (2.) for both sides.
Thread bow string through one side of bow as shown (3.) and
thread through both parts of blasters pull slide (4.) and tie off
on opposite end (5.). Tie knots on both ends to prevent bow
string from coming loose and snapping back during operation.
This Blaster has optional light up effects that activate whenever
the trigger is pulled, this requires 3 x AG13/LR44 button cell
batteries.
Remove battery cover using a screwdriver and install batteries
making sure the polarity is correct. Replace battery cover and
secure with screw.
Note the polarity (+ and - marks on batteries) and install with all
batteries facing the correct direction.
LR44
AG13
+
LR44
AG13
+
LR44
AG13
+
2.
3.
4.
5.
1.