Worx WG305E Safety And Operating Manual Original Instructions - Chain Saw
Chain saw
WG305E
17
3. The Chain (10) must be running at full speed before
it makes contact with the wood.
4. Use the Bumper Spikes (8) to secure the saw onto
the wood before starting to cut.
5. Use the Bumper Spikes as a leverage point while
cutting. (See Fig. K)
6. Do not operate the chain saw with arms fully extended,
or attempt to saw areas which are difficult to reach, or
stand on a ladder while sawing (See Fig. L).
7. Never use the chain saw above shoulder
height.
Cutting wood under tension (See Fig. M)
WARNING: When cutting a limb that is
under tension, use extreme caution. Be alert
for wood springing back. When wood tension
is released, limb could spring back and strike
operator causing severe injury or death.
When sawing logs supported on both ends, start the
cut from above(Y) about 1/3 of the diameter into the
log (overbuck) and then finish the cut (Z) from below, in
order to avoid contact of the chain saw with the ground.
When sawing logs supported on only one end, start the
cut from below (Y) about 1/3 of the diameter into the log
(underbuck) and finish the cut from above (Z) in order to
avoid log splitting or jamming of the chain saw.
SAW MAINTENANCE
Follow maintenance instructions in this manual. Proper
cleaning of saw and chain and Guide Bar maintenance
can reduce chances of kickback. Inspect and maintain
saw after each use. This will increase the service life of
your saw.
NOTE: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAINTENANCE AND STORAGE OF
CHAIN SAW
WARNING: If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
1. Unplug chain saw from power source
• When not in use
• Before moving from one place to another
• Before servicing
• Before changing accessories or attachments, such
as saw chain and guard
2. Inspect chain saw before and after each use. Check
4
7
1
1
2
8
F
G
H
I1
I2
I3
J
K
Injecting grease to lubricate
a
Z
Y
kg
Z
Y
L
M
N
O
P