X-cam GSM110 User Manual - page 2
Setup via Remote Controller
How to use the Remote Controller for Servo Reverse Setup
:
1. Connect to channel CH5 on the Printed Circuit Board (PCB)
2. Push this channel to the highest position on your Remote Controller
3. There will be 3 BEEPs followed by the Red LED flashing, Return the Remote Controller Lever to the middle position to enter the Servo
Reverse Setup mode
4. Move the Remote Controller Lever to the Highest or lowest position to set the Servo Reverse after hearing the BEEPs.
(One BEEP means Channel 1 (TILT) , Two BEEP means Channel 2 (ROLL), Three BEEP means Channel 3 (PAN) ),
If you do not want to change the setup, Just move the Remote Controller Lever to the Middel position.
5. When you hear 4 BEEPs, the setup has been saved.
How to adjust the Acc. Gain:
Rotate the Blue Potentiometer on the PCB for adjust the Acc. Gain.
assemble