1. DL manuals
  2. X-cam
  3. Camera Accessories
  4. X100B
  5. User Manual

X-cam X100B User Manual

Summary of X100B

  • Page 1

    X-cam x100b 2 axis brushless gimbal for gopro user manual x-cam x100b 2 axis brushless gimbal has been finished all adjusting before leaving the factory, users just need to assemble to the aircraft, the pitch of holes is 59mm parameters: weight: 235g (supports gopro1-3) sensor resolution: 0.015 moto...

  • Page 2

    Connection direction uses the 3 in 1 connection wire to connect with your receiver one wire connect to gimbal tilt control channel ( use the wire which has the gnd ) one wire connect to the ail channel one wire connect to the ele channel if you are using a receiver which is no ppm channels such as f...

  • Page 3

    Sensor calibration as the temperature or the sensor error, you may need to do the sensor calibration. There are 2 ways to active sensor calibration program: 1. Pull the ele stick of transmitter to top position while power on until hearing 2 beeps . 2. Via pc software. Note: sensor calibration progra...

  • Page 4

    Pc software connect with pc uses the usb adapter to connect with your pc , normally the windows can find the driver automatically, you could find the port number in the device manager launch the x-cam gimbal stabilization module assistant , choose the correct port number and click connect beep beep ...

  • Page 5

    2. Gimbal control the x100b provides 2 ways to control the tilt, linear mode or tracking mode linear mode: push the tilt stick to high or low for moving the camera mount to up or down until the stick back to midpoint tracking mode: push the tilt stick to high or low, the camera mount will follow the...

  • Page 6

    Disclaimer do not disassemble the x100b and the electronic components any direct or indirect damage caused by the users , we do not assume liability or assume compensation..