X-cam x100b 2 axis brushless gimbal for gopro user manual x-cam x100b 2 axis brushless gimbal has been finished all adjusting before leaving the factory, users just need to assemble to the aircraft, the pitch of holes is 59mm parameters: weight: 235g (supports gopro1-3) sensor resolution: 0.015 moto...
Connection direction uses the 3 in 1 connection wire to connect with your receiver one wire connect to gimbal tilt control channel ( use the wire which has the gnd ) one wire connect to the ail channel one wire connect to the ele channel if you are using a receiver which is no ppm channels such as f...
Sensor calibration as the temperature or the sensor error, you may need to do the sensor calibration. There are 2 ways to active sensor calibration program: 1. Pull the ele stick of transmitter to top position while power on until hearing 2 beeps . 2. Via pc software. Note: sensor calibration progra...
Pc software connect with pc uses the usb adapter to connect with your pc , normally the windows can find the driver automatically, you could find the port number in the device manager launch the x-cam gimbal stabilization module assistant , choose the correct port number and click connect beep beep ...
2. Gimbal control the x100b provides 2 ways to control the tilt, linear mode or tracking mode linear mode: push the tilt stick to high or low for moving the camera mount to up or down until the stick back to midpoint tracking mode: push the tilt stick to high or low, the camera mount will follow the...
Disclaimer do not disassemble the x100b and the electronic components any direct or indirect damage caused by the users , we do not assume liability or assume compensation..