X-Loupe Conceiver series MPG4 PLUS User Manual - Troubleshooting
- 18 -
Troubleshooting
(1) About the troubleshooting of camera, please refer to the Camera User Guide.
(2) The built-in LED of lens barrel is not bright
(3) Error code shown on camera display- the lens barrel of camera can not stretch out
or retract
(4) Could not see the full field of view on the camera monitor
(5) Out of Focus
a. Check the battery power.
b. Disassemble the lens and assemble it back to the module again. Make sure
that the assembling of the lens and module is correct.
c. Check the brightness index of module lighting is not set to zero. If it is, set
back to “entire bright” or the suitable brightness.
a. Turn off the camera power to make the lens retract. Disassemble camera
from the X-Loupe® module, and turn on the power of the camera again.
The lens of the camera should be able to stretch out.
b. If the problem is not solved, contact your local distributor; never try to fix the
camera lens by force because it might void the warranty.
a. Adjust the Zoom of camera to Maximum so that the full field of view can be
obtained.
b. Check the camera lens and make sure that the lens is able to stretch out and
Zoom Function is working.
a. Adjust the direction or posture while shooting.
b. Press the shutter halfway and adjust the distance between the subject and
lens to reach the best focus.
c. X-Loupe® is a contact-based digital microscope; therefore, do not take the
picture out of its short working distance.
Troubleshooting & Storage