Page1 x-140 electric scooter owner’s manual please be safe when riding always wear a helmet and obey all laws! X-treme tm electric scooters.
Page2 battery maintenance and charging instructions 1. You must charge completely prior to initial use. (follow charging instructions in your product handbook) 2. Charge immediately after each use. 3. Charge before storage. You must charge every 30 days if not in use. 4. Charge the unit for 6-8 hour...
Page3 warning this product does not conform to federal motor vehicle standards and is not intended for operation on public streets, roads or highways. Serious injury can result from the unsafe operations of this product. Operator can minimize these risks by using certain safety equipment such as: sa...
Page4 safety guide the recommended age for riding this scooter is 14 years & older. To avoid damage to the motor and footplate, do not overload the scooter. Never ride with more than one person. Inspect your scooter thoroughly before each use for loose or missing parts. Avoid unintentional starts by...
Page5 table of contents important information…………………………………….…………...…2-3 quick reference……………………………………………………………….4 table of contents……………………………….…………….………………5 getting to know your x-treme x-140………………….………………..6 package contents…………………………………………….……………….7 getting started………………..……………………………...………………..7 ...
Page6 getting to know your x-treme x-140 (photo’s may vary).
Page7 package contents your x-treme x-140 comes with the following items in the box. Please locate all of the following: 1. The x-treme x-140 scooter 2. 24v battery charger 3. Tool kit 4. Product handbook getting started please read and understand these instructions and the operating procedures sect...
Page8 fuse installation your scooter comes with a 20amp fuse that may need installed if not done so already at the factory. Follow the instructions below to properly install the fuse before attempting to use your scooter. 1. Locate the 20amp glass fuse that came with your scooter. 2. Locate the fuse...
Page9 riding 1. Make sure that all of the exposed bolts and screws are tightened. 2. Raise the kickstand to its upright position. 3. Push the on/off switch (located on the left side of the scooter frame under the footplate) to the on position. 4. Put one foot on the deck of the x-140 while pushing o...
Page10 adjusting the brakes the brakes on the x-140 should come fully adjusted from the factory. However, it may be necessary to adjust the brakes from time to time. Squeaky brakes the brakes may squeak before they are broken in. This is normal and will not affect the function or performance of the ...
Page11 maintenance recommended tools to adjust and service the x-treme x-140 you will need the following tools: allen wrenches: 3/4/5/6 mm wrenches: 8/10/13 mm open end wrench large adjustable crescent wrench philips head screwdrivers oil, grease or lubricant adjusting the belt the belt wi...
Page12 maintenance schedule proper care of your x-treme x-140 will insure optimal performance and longer life span. The following are a few maintenance suggestions that will keep your x-treme x-140 running in top condition: daily maintenance perform each time you ride your x-140 clean the exterior...
Page13 do not return to store! If you need help call toll free or go online 1-800-772-3852 www.X-tremescooters.Com/support/ for general information or parts visit www.X-tremescooters.Com revised 3/19/10
