Summary of XTD/15A
Page 1
Deflector line deflector line user’s manual 1/12.
Page 2: Deflector Line
User’s manual deflector line user’s manual indice dei contenuti 1. Generalità 2. Istruzioni per l’uso 3. Istruzioni di sicurezza 4. Impilato a pavimento o sospeso? 5. Guida allo stacking 6. Subwoofers 7. Guida generale all’uso dei subwoofers 8. Amplificazione 9. Connettori 10. Lunghezza dei cavi 11....
Page 3: Deflector Line
Deflector line the most important features of this range can be outlined as follows: 1) a higher rigidity/weight ratio; 2) outstanding quality of the speakers and the electronics used in the active versions. Among many reasons why , deflector line features can be distin- guished from those of compet...
Page 4
User’s manual fig. 3 horizontal and vertical installation, maintaining horn orientation 5. Subwoofers the new subwoofer models xtds15 and xtds18 with a pass-band configuration have been designed both physically and acoustically to reach their maximum efficiency – thus the developed energy peak – aro...
Page 5: Deflector Line
Deflector line the xtds15 and xtds18 subwoofers and their corresponding ampli- fied versions both contain a woofer with a 15” neodymium magnet at 1000 w (aes) for the xtds15, and 18” 1200 w (aes) for the xtds18. The maximum spl peaks are respectively 134 db and 136 db. Fig. 8 xtds15 and xtds18 subwo...
Page 6
User’s manual 8. Passive speakers: guidelines and precautions the deflector line comes in both passive and amplified versions. The passive version contains crossover filters with equalization and attenuation cells, designed so that transducer channels have a con- sistent frequency response. This mak...
Page 7: Deflector Line
Deflector line 8.4 power cables it is essential to use power cables with the correct section . If the cables are too long they will cause significant impedance, which can reduce the audio signal quality and alter the dumping factor of the amplifier-speaker coupling. The following table shows the sug...
Page 8
User’s manual fig. 14 details of xtds15/a and xtds18/a rear panel the two switches on amplified subwoofer modules xtds15/a and xtds18/a make possible the following operations: two different low pass cuts and polarity inversion . The lowest frequency cut (90 hz) is adapted correctly to the use with t...
Page 9: Deflector Line
Deflector line fig. 18 deflector 2-way type alpha system configuration (with xtd12/a and xtds15/a) fig. 19 system configuration with xtd15/a and xtds18/a fig. 20 deflector 3-way type alpha system configuration (with xtd1015/a and xtds18/a) 9/12.
Page 10
User’s manual fig. 21 deflector 2-way type beta system configuration (with xtd12 and xtds15, xtdt amplifiers and xtdp26 processor) fig. 22 system configuration with xtd15 and xtds18, xtdt amplifiers and xtdp26 processor fig. 23 deflector 3-way type beta system configuration (with xtd1015 and xtds18,...
Page 11: Deflector Line
Deflector line for a no-compromise dimensioning of the power supplied to the subwoofers, x-treme audio also proposes the following special con- figuration with transducers of 4 ohm and amplification of 1500 w (@ 4 ohm) per channel, which are obtained using a xtdt6000f ampli- fier. This configuration...
Page 12: Www.X-Tremeaudio.Com
12/12 contacts x-treme audio reserves the rights to change or modify products and specifications at any time without prior notice. X-treme and the corresponding symbols, images and registered trademarks are of exclusive property of sound corporation group. © 2010 sound corporation group. All rights ...