Deflector line deflector line user’s manual 1/12.
User’s manual deflector line user’s manual indice dei contenuti 1. Generalità 2. Istruzioni per l’uso 3. Istruzioni di sicurezza 4. Impilato a pavimento o sospeso? 5. Guida allo stacking 6. Subwoofers 7. Guida generale all’uso dei subwoofers 8. Amplificazione 9. Connettori 10. Lunghezza dei cavi 11....
Deflector line the most important features of this range can be outlined as follows: 1) a higher rigidity/weight ratio; 2) outstanding quality of the speakers and the electronics used in the active versions. Among many reasons why , deflector line features can be distin- guished from those of compet...
User’s manual fig. 3 horizontal and vertical installation, maintaining horn orientation 5. Subwoofers the new subwoofer models xtds15 and xtds18 with a pass-band configuration have been designed both physically and acoustically to reach their maximum efficiency – thus the developed energy peak – aro...
Deflector line the xtds15 and xtds18 subwoofers and their corresponding ampli- fied versions both contain a woofer with a 15” neodymium magnet at 1000 w (aes) for the xtds15, and 18” 1200 w (aes) for the xtds18. The maximum spl peaks are respectively 134 db and 136 db. Fig. 8 xtds15 and xtds18 subwo...
User’s manual 8. Passive speakers: guidelines and precautions the deflector line comes in both passive and amplified versions. The passive version contains crossover filters with equalization and attenuation cells, designed so that transducer channels have a con- sistent frequency response. This mak...
Deflector line 8.4 power cables it is essential to use power cables with the correct section . If the cables are too long they will cause significant impedance, which can reduce the audio signal quality and alter the dumping factor of the amplifier-speaker coupling. The following table shows the sug...
User’s manual fig. 14 details of xtds15/a and xtds18/a rear panel the two switches on amplified subwoofer modules xtds15/a and xtds18/a make possible the following operations: two different low pass cuts and polarity inversion . The lowest frequency cut (90 hz) is adapted correctly to the use with t...
Deflector line fig. 18 deflector 2-way type alpha system configuration (with xtd12/a and xtds15/a) fig. 19 system configuration with xtd15/a and xtds18/a fig. 20 deflector 3-way type alpha system configuration (with xtd1015/a and xtds18/a) 9/12.
User’s manual fig. 21 deflector 2-way type beta system configuration (with xtd12 and xtds15, xtdt amplifiers and xtdp26 processor) fig. 22 system configuration with xtd15 and xtds18, xtdt amplifiers and xtdp26 processor fig. 23 deflector 3-way type beta system configuration (with xtd1015 and xtds18,...
Deflector line for a no-compromise dimensioning of the power supplied to the subwoofers, x-treme audio also proposes the following special con- figuration with transducers of 4 ohm and amplification of 1500 w (@ 4 ohm) per channel, which are obtained using a xtdt6000f ampli- fier. This configuration...
12/12 contacts x-treme audio reserves the rights to change or modify products and specifications at any time without prior notice. X-treme and the corresponding symbols, images and registered trademarks are of exclusive property of sound corporation group. © 2010 sound corporation group. All rights ...