X10 Europe UR76 E User Manual - page 4
UR76 E REMOTE CONTROL
Quick start guide
1) Put the batteries in
1. Open the cover on the back of the UR76E
2. Insert 2 batteries (LR03 alkaline). Make sure the batteries are the same brand
and are NEW
2) Programme your UR76E
1. Turn on the equipment that you wish to control (TV, VCR, DVD, SAT, CD etc ...)
2. Take the code book supplied with the UR76E and find the brand of the
equipment you wish to control. E.g. if you have a Thomson TV look for Thomson
under the TV section.
3. Press on the key marked « SETUP » (2) pressing the key until the red LED stays
permanently bright. This takes about 3 seconds.
4. Press on the TV, VCR, DVD, SAT... mode key (4), in accordance with the
appliance you wish to control.
5. From the code book take the first number corresponding to your equipment and
enter the number by pressing the 0-9 key pad (11). Each time you press a key
the red LED (1) will flash.
6. If the number is correctly entered the red LED will switch off. If the number is
incorrect then the red LED will flash fast. If incorrect you will need to begin at 1.
7.
Alternative to 5:
If your brand is listed hereafter:
BRAND
Philips/Radiola
Sony/Panasonic/JVC/
Akai/Toshiba/Daewoo
Thomson/Brandt
Sharp
CODE
1
2
3
BRAND
Telefunken/Saba/Normende
Grundig/Blaupunkt
Nokia/ ITT
CODE
4
5
6
Enter the code corresponding to your brand, point the UR76E in the direction of
your equipment, press once only CHANNEL+(6) continue to point the UR76E at
your equipment until the equipment changes channel. (The remote control sends
an IR signal every second. So please wait until your equipment reacts). When your
equipment does react, press on the key --/- (13) to confirm. If accidentally you
miss the code, you can stop the autosearch by pressing CHANNEL – (6) and by
repeatedly pressing this key return to the right code. Press --/- (13) to confirm.
8. Press on the key POWER (3). If your equipment switches off you have found
the right code. If it does not switch off, you will need to re-start from 1.
Sometimes there are several codes which have similar features. If you find that
your UR76E does not work for some functions, you may need to search for another
code.
-3-