X4-TECH A-1200 Instruction Manual - General Operation
22
23
Turning on and playing an audio source
Check that all connections are secure and proper, before turning the device on for the
fi rst time.
› The main switch should be switched on fi rst (position – ON), before putting the device into
operation.
› The current selected input source will appear on display, for example DVD/CD.
› Rotate the „VOLUME“ control dial completely to the left.
› Turn the audio source on, for example your CD player.
› Select the desired sound source by pressing the respective input source button (e.g. DVD/CD).
If the end device to be used is connected to a diff erent connection, then select the respective
input source accordingly (such as Tape/AUX, DVD/CD, Tuner or DAB).
› Start playback of the selected playback source (e.g. CD player).
› Rotate the „VOLUME“ control dial in a clockwise motion to the desired listening level.
Warning
Please note that one should never listen to high volume levels for longer periods of time. This
could damage your hearing. This applies especially to listening to music with earphones or head-
phones. Excessive sound pressure levels created when listening to loud volume levels with ear-
phones or headphones can lead to permanent hearing damage. Set the volume to a minimum
before using earphones/headphones and try to maintain a comfortable volume level thereafter.
› You can press the „FUNCTION“ button to access the sound settings mode. Refer to next section
for more information on this function.
› Before turning the amplifi er off , rotate the „VOLUME“ control dial completely to the left fi rst and
then press the POWER button to turn the amplifi er off .
› Failing to comply with the above sequence could cause damage to the loudspeakers or the
amplifi er.
Chapter 6
General operation
Chapter 6
General operation
Sound settings
Press the „FUNCTION“ button on the device to select one of the following setting modes:
Selection
Control dial
BAS
Regulates the bass intensity by rotating the control dial.
TRE
Regulates the treble intensity by rotating the control dial.
BAL
Regulates the balance by rotating the control dial.
LOU OFF
Select this mode to add an additional sound eff ect.
RESET
Selecting „RESET“ and rotating the control dial returns all settings to a
factory default setting.
› You can use the „TREBLE +/–“ and the „BASS +/–“ buttons on the remote control to directly
adjust treble and bass settings. Balance settings can only be carried out directly on the device.
6