X4-TECH IR-1600 User Manua - Internet Radio Ir-1600
28
Internet radio IR-1600
1. Connection type
Select the preferred connection type:
Wireless (via wireless network)
2. DHCP
Select if the Direct Host Configuration
Protocol (DHCP) is to be used:
DHCP enable Activates use and switches
to the automatic reception of network data.
DHCP disable Deactivates use and carries
on with the manual entry of network data.
3. IP settings
Set the IP address and the Subnet mask with
„p“ and „“ or with the „CONTROL“ dial. Use
the „“ and „“ buttons toswitch between
fields. Press „ENTER“ to switch to the next
field.
4. Gateway address
Set the Gateway address with „p“ and „“ or
with the „CONTROL“ dial. Use the „“ and „“
buttons to switch between fields. Press
„ENTER“ to switch to the next field.
5. DNS
If the DHCP has been deactivated, then the
primary and secondary DNS address can be
set with „p“ and „“ or with the „CONTROL“
dial. Use the „“ and „“ buttons to switch
between fields. Press „ENTER“ to switch to the
next field.
6. SSID
Set the wireless network identification. Use
the navigation buttons or the „CONTROL” dial
to move the cursor through the displayed
characters. Press either the „ENTER” button
or the „CONTROL” dial to confirm the selected
character.
➝
Select „BKSP“ to delete the last character
selected.
➝
Select „CANCEL“ to cancel your input.
➝
Select „OK“ to confirm the entered code
and to try to establish a connection to the
selected network.
7. Authentication
Now set the preferred method of authentica-
tion. Open, Pre-Shared Key (PSK), WPA (Wi-Fi
Protected Access) or WPA2.
8. Encryption type
Now select the appropriate encryption type.
Disabled (off ) or WEP (Wired Equivalent
Privacy) for Open or PSK, TKIP (Temporal Key
Integrity Protocol) or AES (Advanced Encrypti-
on Standard).
9. Key
Now enter the code for the wireless network.
Use the navigation buttons or the „CONTROL”
dial to move the cursor through the displayed
characters. Press either the „ENTER” button
or the „CONTROL” dial to confirm the selected
character.
➝
Select „BKSP“ to delete the last character
selected.
➝
Select „CANCEL“ to cancel your input.
➝
Select „OK“ to confirm the entered code
and to try to establish a connection to the
selected network.
Now the device will try to establish a connec-
tion using the data previously entered.
Network profile
You can use the options MENU System
settings Network Network Profile to
delete an unwanted network. Here you will
see a list of the previously used wireless
networks. Select a profile with the „p“ and
„“ buttons and press „ENTER“. Confirm with
„YES” to delete.