X4-TECH TITAN DT9 Instruction Manual - Connections
22
23
Chapter 5
Connections
Chapter 5
Connections
Power supply
› Turn the device off. Connect the power adapter’s connector to the DC IN 9 –12 V
power supply connection on the device. Now you can plug the power adapter’s
plug into a power outlet that has been correctly installed according to your public
power system. To operate via your car’s cigarette lighter, connect the car adapter’s
connector to the DC IN 9 –12 V power supply connection on the device. Now you
can plug the adapter into your car’s cigarette lighter.
Please bear in mind that the device consumes a minimal amount of po-
wer, even in a standby mode. Please take this into consideration when
operating the device with your vehicle’s electrical system. Remove the
adapter from the power supply source in order to completely cut off the
power supply to the device.
A/V IN
› You can connect an external signal source to this connection (for example a
game console). Please refer to the user manual accompanying this device in or-
der to connect.
A/V OUT
› You will be able to use your Titan as a signal source for an external device with
this connection (for example as a monitor). Please refer to the user manual ac-
companying this device before connecting.
Earphones
› You can connect a set of earphones to this jack. Speakers are muted, once ear-
phones are plugged into the device.
Listening to earphones at higher volumes over a longer period of time
can damage your hearing or even cause permanent hearing loss.
USB connection
› USB flash drives with a capacity of up to 4 GB and SD, MMC, RS-MMC and SDHC
memory cards in combination with the included adapter can be connected to
the USB 1.1 for use.
› The storage medium must be formatted to FAT 32.
› Never use connection cables longer than 25 cm with this device.
› Hard discs can not be used with this device.
Please note that USB cables connected must be less than 3 m in length in
order to maintain EMC compliance. Using cables longer than 3 m could
influence electromagnetic compatibility, which could lead to disturbance
or failure.
The USB connection does not warrant the supply of power to the external
medium used, for example a hard disc. Please refer to the user manual ac-
companying the device connected to your TITAN.
Connections
5