X4-TECH TP-1000 Operating Instructions Manual - page 18
34
35
(6)
REC LEVEL control
This control serves for adjusting the signal gauge when recording (only active when re-
cording external audio sources, when recording with deck A the recording will automati-
cally be adjusted.)
(7)
Tape deck buttons
REC: Press this button at the same time with button (PLAY) to start the recording.
PLAY: Press this key for replay.
REW: Press this key to rewind the cassette.
FF: Press this key to forward the cassette.
/ STOP/EJ.: Press this button once to stop the driving function, press again to open
the cassette case.
PAUSE: Press this button to interrupt the replay or the recording shortly. By pressing
again the brake function will be switched off .
(8)
Button REC CrO
2
Press the button to record to a CrO
2
-Cassette.
(9) Button
HI.SP.DUB.
With this button the fast copy function from deck A to deck B is activated (always only in
combination with the button DUBBING (10)).
(10) Button
DUBBING
With this button the copy function from deck A to deck B is activated.
(11) Button PLAY CrO
2
Press the button to play a CrO
2
-Cassette.
Play a cassette
› Playing cassettes is possible in both decks (A and B).
› Press the key POWER (1) to switch on the device.
› Press the / STOP/EJ button. The cassette compartment (2) opens.
› Put a recorded Cassette with tape opening downwards in the drive.
Chapter 5
Operation
Chapter 5
Operation
› Close the drive.
› Select the Tape-input on your amplifi er.
› If it is a CrO
2
-Cassette, press the button PLAY CrO
2
(11). When the button is activated agreen
control LED fl ashes on the display (4) above the button.
› Put the switch NOISE REDUCTION (3) into the correct position for this cassette.
› The cassette was recorded with the hissing reject system > put switch to ON.
› The cassette was recorded without the hissing reject system > put switch to OFF.
› Press the keyPLAY.
› The playing starts.
› Press the buttonPAUSE to interrupt the replay shortly. To continue replay press buttonPAUSE
again.
› Press the button / STOP/EJ once, to stop the replay.
› Press the button / STOP/EJ again, to remove the cassette.
The replay ends automatically when the tape ends.
Please do not forget to turn your tape deck off after use.
Fast-forward and rewind
› Before you can forward or rewind the cassette, you must end the replay with the button
/STOP/EJ.
› Press this key FF to forward the cassette.
› Press this key REW to rewind the cassette.
› Press the button/STOP/EJ, to stop the forwarding or rewinding.