X4-TECH X-Cept Car Mini Instruction Manual - Safety Information
6
7
Chapter 2
Safety information
Chapter 2
Safety information
› Should any evident damage be seen on the device or on
the connection cables, do not come in contact with or touch
these. Switch off the corresponding circuit breaker in the po-
wer distribution panel first, before carefully unplugging the
power plug from the wall outlet. Do not operate this device
further! Please contact or take it to a qualified service techni-
cian/specialty workshop.
› In order to completely cut off the power supply to the de-
vice, unplug the power plug from the wall outlet. Merely tur-
ning the device off with the ON/OFF button is not sufficient
enough. Make sure that receptacles are easily accessible.
› Always pull on the plug’s grips and never on the cable to
remove from a wall outlet.
› Unplug the device from the power outlet, if it is not in use
for a longer period of time.
› For safety reasons, always unplug the device from the po-
wer outlet during thunderstorms.
› Eliminate potential tripping hazards by routing cables in
such a way that no one can trip or stumble over them.
› Never use the device, if the power cable or device is da-
maged.
This device is not suitable for children under
3 years of age.
Small children are unaware of the serious and imme-
diate dangers involved when exposing themselves
Dear customer,
the following safety and hazard warnings are not only for the protection
of your device, but also serve as a protection against potential health
hazards. Please take time to read the following instructions carefully.
We assume no liability for personal or property damage
resulting from the failure to comply with the safety in-
structions, improper operation and handling. Under such
circumstances, all claims under warranty will become void.
› For safety and licensing (CE) reasons any unauthorized mo-
dification and/or change on the device is prohibited and will
void the warranty and all warranty claims.
› Any persons operating, installing, setting up, or servicing
this device must be trained and qualified accordingly and
observe these operating instructions.
› Ensure that the device has been set up accordingly by fol-
lowing all instructions found in the instruction manual.
› Power supply cables should be routed so that they are not
likely to be walked on, squished or pinched by items placed
upon or against them, paying particular attention to cords at
plugs, convenience receptacles, and the point at which they
exit from the device. Avoid exposing the cable to extreme
heat or cold. Ignoring the above mentioned could result
in cable damage and present the dangerous risk of electric
shock.
Safety information
2