________________________________________________________________ repacking procedure 1 ® ® repacking procedure version 1 3/29/01.
2 repacking procedure __________________________________________________________________ trademarks xantÉ ® , accel-a-writer ® , and screenwriter ® are registered trademarks of xantÉ corporation, registered in the united states patent and trademark office. Stockmaker™ is a trademark of xantÉ corpora...
________________________________________________________________ repacking procedure 3 if you have a toner vacuum, use it to remove all loose toner in the printer before shipping it. Removing cables, cassette(s), and media 1. Turn off the power to the printer, and if a 2,000 sheet feeder is attached...
4 repacking procedure __________________________________________________________________ 3. Store the toner cartridge in its original package following the appropriate guidelines in “handling the toner cartridge” in the printer user’s guide. 4. Close the top cover by pressing down on the center sect...
________________________________________________________________ repacking procedure 5 3. Push the multipurpose feeder’s tray extension back in (fig. 8); then, close the multipurpose feeder (fig. 9). Fig. 8 close the tray extension fig. 9 close the multipurpose feeder 4. Repack the oversize media su...
6 repacking procedure __________________________________________________________________ removing a 2,000 sheet feeder if a 2,000 sheet feeder is attached to your printer, it must be removed before the printer is shipped. 1. Make sure the feeder’s power cord is disconnected and any media is removed ...
________________________________________________________________ repacking procedure 7 fig. 15 remove the allen screws fig. 16 detach the footers 5. Unlock the casters on the front bottom of the feeder (fig. 17). Turn the locking key on the top of the feeder clockwise to relock it (fig. 18). Fig. 17...
8 repacking procedure __________________________________________________________________ 2. Disconnect the duplexer cable (fig. 21) and lift the duplexer off of the printer and set the duplexer on its back (fig. 22). Fig. 21 disconnect the duplexer cable fig. 22 remove the duplexer 3. Insert the dup...
________________________________________________________________ repacking procedure 9 2. Place the two pieces of base foam in the bottom of the shipping box; the slightly wider piece goes to the front (fig. 24). Outer box toner box paper tray box side foam side foam printer base foam base foam box ...
10 repacking procedure __________________________________________________________________.
