Xante Accel-a-Writer Accel-a-Writer 3DN Supplementary Manual - page 9
________________________________________________________________
Repacking Procedure 9
2.
Place the two pieces of base foam in the bottom of the shipping box; the slightly wider piece goes
to the front (fig. 24).
Outer Box
Toner Box
Paper Tray Box
Side Foam
Side Foam
Printer
Base Foam
Base Foam
Box Base
Cardboard
Support
Fig. 24 Reassemble the Shipment Package
Warning!
The printer weighs approximately 101 lbs (46 kg) without toner, cassettes, and media installed.
Always have two people lift the printer by the recessed grip areas on the bottom sides.
3.
Lift the printer with the help of another person, and if you still have the printer’s orginal protective
plastic bag, place the printer back into this bag. Then, align the printer to face the wider piece of
base foam and lower the printer into its box.
4.
Reassemble the shipment as shown in figure 24, making sure all necessary parts are included. See
“Repacking” earlier in this addendum to determine which parts should be included in the shipment.
Note:
Manuals and documentation will fit in the output tray on top of the printer; the power cord will
fit under the toner cartridge box in front of the multipurpose feeder. If you are returning these
items, cushion them with crumpled paper to hold them in place during shipment.
5.
Make sure the outer box fits completely down, covering the sides of the box base. Then use heavy-
duty packing tape to tape the outer box securely to the box base.
◊◊◊