Xantech MRC88M Quick Start Instructions - page 4
-
4
-
Configuring the MRC88m keypad to control the XIS100
The XIS100 is controlled by using the new “Metadata” Internal Commands. These new commands
can be used to control the XIS100, the XMusic, and the iPort. There is a table at the end of this
document that describes how each Metadata internal command maps to the XIS100 remote button.
1) Just above the Virtual Keypad (under the “Keypad” tab), select “Zone 1” from the drop-down box.
2) On the Virtual keypad, select SRC1.
3) On the right-hand portion of the Dragon window, make sure that the “Internal Commands” tab near
the bottom of the window is selected.
4) On the Virtual Keypad, select the “
Ç PAUSE” button.
5) In the “Internal Commands” window, select the “Metadata Up” command.
6) In the “Zone” area, select the current zone, Zone 1.