Xantech SPLCDCB100 Installation Instructions

INSTALLATION INSTRUCTIONS 

MODEL SPLCDCB100 

SmartPad LCD™ Amplified IR Connecting Block 

TABLE OF CONTENTS 

Table of contents ..................................................................................................................................................1 

Introduction ...........................................................................................................................................................1 

Features:...........................................................................................................................................................1 

Specifications:...................................................................................................................................................2 

Installation.............................................................................................................................................................2 

Power Wiring: ...................................................................................................................................................2 

SPLCD IR Wiring: .............................................................................................................................................2 

SPLCD Wiring Over CAT5:...............................................................................................................................3 

IR Receiver Wiring:...........................................................................................................................................3 

High IR Out Wiring:...........................................................................................................................................4 

INTRODUCTION 

The SPLCDCB100 Connecting Block allows any combination of SmartPad LCD™ panels and standard Xantech IR 

Receivers to be connected in parallel while providing 10 Amplified Emitter outputs (expandable to 100 Emitter Outputs). 

The SPLCDCB100 allows central 16VDC powering (for SmartPad LCD™ panels) and includes a regulated 12VDC 

Voltage output for powering all standard Xantech IR Receivers (such as the 291-90, 490-90, and 780-90 Plasma Series). 

This enables all devices to be wired back to the head-end for centralized wiring distribution.  

The SPLCDCB100 also features 10 amplified emitter outputs to assure proper emitter signal strength allowing for longer 

emitter runs (up to 500ft with 18AWG wire). The SPLCDCB100 emitter output can also be expanded using Xantech’s 790-

00 Emitter Expansion Block to accommodate any project. 

FEATURES: 

•  Screw-Terminal Connections for Voltage, Status, IR and GND for SmartPad LCD™ Connection 

•  Built-In 12vDC Regulator for powering Xantech IR Receivers 

•  10 Amplified Emitter Outputs for Xantech full line of IR Emitters (282M, 283M, 284M etc..) 

•  3.5mm Quick-Connect Jack for easy IR Receiver Input (also screw-terminal connection for IR Receivers) 

•  High IR OUT for expansion to Xantech 790-00 Connecting Block (Connect up to nine 790-00 for a total of 100-

Emitters) 

•  IR Talk Back LED for system verification 

•  Easily mounts to flat wooden, plastic, or metal surfaces using the included screws.