Xantrex Truecharge 20+ Amp Owner's Manual - page 25
Manual is about: Xantrex Truecharge Multistage Battery Charger
of
78
Preparing for Installation
2–7
Tools
To mount and connect Truecharge+ you need:
❐
a slot screwdriver with a maximum 3/16 in wide blade for the DC
terminals
❐
a No. 1 Phillips screwdriver for securing the AC wiring compartment
cover
❐
a wire stripper
❐
the manufacturer's recommended crimp tool for any crimp terminals
that are being used
Materials
You need the following material:
❐
3 conductor No. 14 AWG AC cable
❐
Appropriately sized DC cables for each battery, with suitable
connectors at the battery end
❐
DC fuse and disconnect or circuit breaker for each battery bank
❐
Mounting hardware (#8 recommended), minimum 4.
❐
Other means to route and secure AC and DC wiring