Xblue Networks PCS Mail Installation Manual - page 24
PCS
- 24 -
| Installation Manual |
Expansion Card (8907-06)
Installation:
Care should be taken when handling any Printed Circuit Boards (PCB). When
necessary be sure to use an antistatic wrist or grounding strap while handling or
installing any PCB. Additionally, PCB’s should only be handled by their edges,
never touch any of the electronic components.
1. Remove the Memory Expansion Card from the box and inspect for any
shipping damage. If it is damaged in any way do not continue.
2. Open the voicemail cover.
o
Digital
Voicemail – to remove power form the system, unplug the
line cord from the connector labeled “J1”.
Locate the pin connector “J4” – in the upper left
Match the pin connector adaptors and press the card in
firmly but do not over flex the motherboard.
Be sure to secure the bottom of the card with the supplied
plastic connector.
Restore power by plugging in the line cord into connector
“J1”.
o
Analog
Voicemail – to remove power from the system, unplug the
power adapter “J6”.
Locate the pin connector “J7” – in the upper left
Match the pin connector adaptors and press the card in
firmly but do not over flex the motherboard.
Be sure to secure the bottom of the card with the supplied
plastic connector.
Restore power to the system, insert the power plug in “J6”
3. Close the voicemail cover.
4. To verify the memory expansion – refer to the programming section.
Pin Connector “J4”
Expansion Card
Pin Connector “J6”
Expansion Card