Xceed X2300KS Instruction Manual - Preparing The Generator
12
Automatic voltage regulator (AVR)
This generator has been equipped with AVR technology
which provides automatic voltage regulated power for a
continuous uninterrupted stable power supply.
The AVR maintains a regulated AC output and reacts
substantially quicker to rapid surges in voltage, therefore,
reducing the possibility of damage to the generator and
attached equipment.
However, it is strongly suggested to use a surge protector
on the output of the generator.
The generator is also not recommended to be used on
electronic or sensitive equipment like computers, televisions
and similar devices. This also includes caravans which have
built in electronic inverter equipment.
What the Xceed 2300W generator is for:
•
Lights
•
Hand tools
•
Dryer
•
Fry pan
•
Washing machine (non electronic)
•
Small pumps up to 400W
•
Small refrigerators (Non electronic)
•
Power tools up to 600W
•
Heaters up to 900W
•
Pumps up to 1000W
•
Large refrigerators up to 1000W
•
Hand tools up to 1500W
•
Stationary tools up to 1200W
•
Heaters up to 2000W
•
Household NON electronic appliances up to 2000W,
ie. kettles, toasters
The Xceed 2300w generator is not recommended for use
on sensitive electronic equipment including LCD / plasma
televisions, computers, microwaves etc, and including
caravans which have internal inverter controls.
It is also recommended to use a surge protector on the
outlets of the generators.
Preparing the generator
It is important to check the generator before you commence
operating the unit.
IMPORTANT. Ensure that the engine is fully filled with oil.
When leaving the factory, this generator has NO OIL in
the engine.
Note. The engine will not start if the generator has no oil
or low oil.
Checking the engine fuel
1. Switch off engine by moving the ignition switch (12a or
12b) to the ‘off’ or ‘O’ position.
2. Check the fuel level by viewing the fuel level gauge (3)
or removing the fuel cap (2) to check.
3. If the fuel is low, remove the fuel cap (2) by turning
anticlockwise.
4. Check to ensure the fuel filter screen is inside the fuel
filter neck.
5. Pour the unleaded fuel from an approved fuel container into
the fuel tank (1). Because fuel expands, DO NOT FILL to
the lip of the tank. Max. fill is to the top of the fuel filter rim.
6. Replace fuel cap (2) and turn clockwise to lock.
WARNING.
•
Do not refill fuel tank (1) while engine is running or is hot.
•
Check to ensure that the fuel drain (16) has been
tightened and that fuel is not leaking.
•
Be careful not to admit dust, dirt, water or other foreign
objects into the fuel.
•
Wipe off spilt fuel thoroughly before starting engine.
•
Ensure you DO NOT fuel the generator in close proximity
to any open flames, lit cigarettes, or hot objects.
•
The generator should also be located in an open area
with fresh air and NOT in a confined area.