Xceed X2300KS Instruction Manual - Stopping The Engine
15
Starting the engine manually
Note. Follow steps 1 to 3 of
the ‘Starting the engine with
key start’ section.
1. Turn the key start ignition
(12) clockwise to the ‘ON’
(Fig. I1).
2. Slowly pull the recoil starter
(23) until you feel it engage
and then pull it briskly.
3. Once you hear the motor
operating, move the choke lever (14) back to the run
position (refer point 6 above).
Stopping the engine
1. Before stopping, ensure that no electrical apparatus is
connected to the generator.
2. Turn the key start ignition
(12) to the ‘OFF’ position
(Fig. J1).
3. Turn the fuel lever anti
clockwise to the ‘off’ position.
Connecting apparatus
to the generator
Start the generator and allow
the generator to run for
a few minutes to warm up.
240V AC Connection
Check the total rating of the
appliance to be connected
and ensure the rating of the
appliance/s does not exceed
the rating of the generator.
Turn off the AC circuit breaker.
Check the appliance to be connected is turned ‘OFF’.
Insert the 3 pin plug into the 240V outlet socket of the
generator (Fig. K).
The circuit breaker can be switched to the ON position and
the appliance then turned on.
K
J1
I1