XDrum DD-505 User Manual - Setting
12
You can adjust the sensitivity(gain) of the inputs from pads.
1. Hold down [ kit ] and press [ voice / volume ] buttons.
Display shows: "EXX", the pad sensitivity value is indicated.
(XX=gain level value, 00 to 15.)
2. Press [ pad ] button or hit the pad you want to set.
The pad indicator light .
3. Press [ + ] or [ - ] buttons to adjust the sensitivity of pads.
Range : 00-15
Large values will produce a high sensitivity even if the pad
is hit softly.
Lower values will producing a low sensitivity even if the pad
is hit forcefully.
4. Repeat step 2 and 3 for to set the voice for another pad or
bass drum.
Note:
1. After adjusting the sensitivity value, you can save them into
built-in memory. In the sensitivity mode, the sevstivity value is
displayed, press [ save ] button and then return to previous display.
2. The drum remains untouched for 10 seconds, the LED will
return to previous display.
3. If turn off the power without save, you will lose the changes
you have just made.
Setting
Adjust the pad Sensitivity
Prevents crosstalk caused by pads or drums connected to other
inputs. Events triggered by other pads that are of a lower input
value than what is set here will not be delivered for a set lenght
of time.
1. Hold down [ voice / volume ] and press [ song / volume ] buttons.
Display shows: "JXX", the rejection value is indicated.
(XX=rejection level value, 00 to 15.)
2. Press [ pad ] button or hit the pad you want to set.
The pad indicator light .
3. Press [ + ] or [ - ] buttons to adjust the sensitivity of pads.
Range : 00(no rejection)-15
4. Repeat step 2 and 3 for to set the voice for another pad or
bass drum.
Note:
1. After adjusting the rejection value, you can save them into
built-in memory. In the rejection mode, the rejection value is
displayed, press [ save ] button and then return to previous display.
2. The drum remains untouched for 10 seconds, the LED will
return to previous display.
3. If turn off the power without save, you will lose the changes
you have just made.
Set the rejection for each pad