Xeecom VENTUS W232 Owner's Manual - page 13
12
“Search Now”. Press [Enter] to confirm and it will switch to WEATHER display mode and start searching
for remote sensor. The “
“ icon flashes indicating it is searching for remote sensor.
2. During the RF searching, press [TX] button inside the battery compartment of the remote sensor to
enforce transmitting signal to the receiver.
3. When RF connection is established, the respective temperature & humidity of the selected outdoor
channel will appear on the weather display mode.
RADIO-CONTROLLED CLOCK SETTING
Once the photo frame is connected to the adapter and the RF remote sensor reception is completed, the unit
will start synchronizing the radio-controlled clock. The display of the photo frame will be turned off during
radio-controlled clock reception to avoid interference from the display panel. Select “
√
” when the following
message appears.
“Start radio-controlled clock reception now?
(Display will turn off for 10 minutes during reception)”
The display will turn off around 10 minutes to receive radio-controlled clock signal.
If the reception is successful, “
” antenna icon with full signal strength will appear on the weather display
mode next to the clock. If the “
” icon does not appear, radio time signal is not available at the moment. Try
other locations later. Place the unit away from source of interference such as mobile phones, appliances, TV etc.
The photo frame also has a daily synchronization at around 2:03 am & 3:03 am
To enforce searching for radio-controlled clock signal, go to Setup display mode. Press [UP] or [DOWN] to
select “Radio-Controlled Reception.” Press [LEFT] or [RIGHT] to select “Search Now” and press [Enter] to
confirm. Then select”
√
“ when the message “Start radio-controlled clock reception now?” appears. The display
will turn off and start the radio-controlled clock reception.
(During radio-controlled clock reception, you may turn on the display by pressing any button, however, doing so
will terminate the reception)
WEATHER FORECAST SETTING
To obtain an accurate weather forecast, you need to input your current weather condition as initial setting.
Go to “SETUP” display mode and use [UP]/[DOWN] to select “Weather Forecast”. Press [LEFT]/[RIGHT] to
select your current weather condition between “Sunny”, “Partly Cloudy”, “Cloudy”, “Rainy” or “Stormy” as the
initial weather forecast setting. Press [ENTER] to confirm setting and [EXIT] to exit the “SETUP” mode.
The unit predicts weather condition of the next 12 – 24 hours based on the change of atmospheric pressure.
The coverage area is around 30 – 50 km. The weather forecast is based on atmospheric pressure change and
is about 70-75% correct. As weather conditions cannot be 100% correctly forecasted, we cannot be
responsible for any loss caused by an incorrect forecast.