Xeecom VENTUS W232 Owner's Manual - page 17
16
Press [SLIDESHOW] to enable or disable the slideshow
To set the calendar, enter SETUP mode for setting
SETUP MODE
Press [UP]/[DOWN] to move to your setting item. Press [LEFT]/[RIGHT] to select the setting and press [ENTER]
to confirm the setting.
Language:
Select between English, Dutch & French
Slideshow Time:
Select between 3s, 5s, 15s, 1 min, 15 min & 1 hour for photo slideshow mode
Transition Effect:
Select the transition effect of the photo slideshow mode
Photo repeat mode:
Select between random, manual or repeat all for the photo slideshow mode
Display mode:
Select the photo display mode (cinema, stretch, crop)
On/Off Timer 1 - On:
Adjust the first automatic power on time in HH:MM; enable or disable
On/Off Timer 1 - Off:
Adjust the first automatic power off time in HH:MM; enable or disable
On/Off Timer 2 - On:
Adjust the second automatic power on time in HH:MM; enable or disable
On/Off Timer 2 - Off:
Adjust the second automatic power off time in HH:MM; enable or disable
(For power saving, you can select when to turn on or off the photo frame
automatically throughout the day using the On/Off timer 1 or 2)
Brightness:
Select the brightness of the display from level 1 to 16
Contrast:
Select the contrast of the display from level 1 to 16
Saturation:
Select the saturation of the display from level 1 to 16
Radio-Controlled Clock:
Enable or disable the radio-controlled clock (Default: enable)
Radio-Controlled Reception:
Automatic - search for radio-controlled daily at around 2:03am
Search now - start searching for radio-controlled clock signal
Off – turn off the daily radio-controlled clock reception
Time Offset:
Adjust the clock to your local time using the time offset setting
Time:
Adjust the calendar and time
(You need to do this if your photo frame cannot receive radio-controlled clock
signal)
Calendar Display Format:
Select between Day/Month or Month/Day format
Time Format:
Select between 24 & 12 hour format
Alarm:
Adjust the alarm time and enable/disable the alarm
Wireless Sensor Reception:
Automatic – default RF reception mode
Search now – Search for remote sensor immediately
Temperature Unit:
Select between degree C & F for temperature, heat index & dew point
Weather Forecast:
Select between sunny, partly cloudy, cloudy, rainy & stormy
Pressure Unit:
Select pressure unit between hPa, mmHg, inHg & mb
Remote Channel Display:
Automatic – Show the channel(s) being registered
Channel 1 only – Shows only channel 1 reading only