Xenarc 1020TSH Installation Manual - page 8
8
│
Remote Control
Instructions for remote controller shortcuts
1. Dimmer ( Adjust the brightness )
By pressing the Dimmer button, it will adjust the brightness level from
0, 20, 40, 60, 80 and 100.
Default is 100 ( Only available when auto sensor is disable
d
)
2. Sleep ( Set the sleep time out )
Select the time to automatically turn off the monitor.
The min
i
mum is 15 minutes and the maximum is 120 minutes.
3. Picture ( Set the mode
s
of the picture )
Enable to select the picture mode
s
you prefer.
Press this button and then you can select standard, user, bright, or soft.
4. PC AUTO ( Auto adjust, only on VGA )
By pressing PC AUTO, it will auto adjust the image.
5. Source ( Select the source )
Press this button to select the input signal to display.
If one of these mode
s
is disabled in OSD menu, please setup under
( Function → Sou
rce Enable )