Xenarc 104OTS User Manual & Installation Manual - page 3
3
I.
Introduction
‐ This monitor produces clear images with vivid colors at resolutions from VGA up to
XGA. It uses a graphics adapter of scanning frequency from 30KHz to 82KHz in horizontal sweep
while vertical refresh rate is 56Hz to 76 Hz continuously.
‐ On Screen Display provides flexibility with simple & user‐friendly controls.
‐ Integrated D‐sub and HDMI inputs provide flexible connectivity for high‐definition multimedia
devices and gaming consoles
‐ Optional built‐in 2W x2 Speakers
‐ USB interface 5‐Wire Resistive Touch Panel
‐ 1040TS: 10.4” panel with VGA & HDMI input, and 5‐Wire Resistive touch screen.
Features
-
10.4 inch diagonal screen with native display resolution 800 * 600
-
Dual Video input: VGA, HDMI
-
Full flat front panel with high quality resistive touch panel
-
Rimless front bezel design; IP54 spill & dust proof
-
Cable management down routing through the mounting stand
-
Light weight, only 1320g physically
-
5 Wire Resistive Touch Panel Control Function
-
Mitsubishi PMMA cover lens for P104MG
Unpack the monitor
-
Put the monitor on a clean surface; make sure the box is in an upright position.
-
Remove packing materials from inside of box.
Check accessories
Please make sure the all accessories are included:
1.8 meter VGA 15 pin
Power Adaptor
D‐sub Video cable
USB cable for P104MR