Xenarc 700TSU Installation Manual - page 8
Instructions for remote controller shortcuts
1. Dimmer (adjust the brightness)
By pressing the Dimmer button, it will adjust the brightness level from 0, 20, 40, 60, 80
and 100. Default is 100 (Only available when auto sensor is disabled)
2. Sleep (set the sleep time out)
Select the time to automatically turn off the monitor.
The minimum is 15 minutes and the maximum is 120 minutes
3. PICTURE (set the mode of the picture)
Enable to select the picture mode you prefer. Press this button and then you can
select standard, user, bright or
soft
4. PC AUTO (auto adjust, only on USB Video)
By pressing PC AUTO, it will auto adjust the image.
5. SOURCE (select the source)
Press this button to select the input signal to display (USB Video, AV1, AV2).
If one of these mode is disabled in OSD menu, please setup under
(Function --> Source Enable)
|
8
Remote Control