Xerox DocuMate 5445 User Manual - page 196
Xerox
®
DocuMate
®
5445 / 5460
User’s Guide
196
•
Preset overrides capabilities—some scanning applications have the option to adjust the scan settings and
scan without opening this scanner interface. The next time this interface opens, the last used settings will
match the application settings that were used to scan. Select this option to have the settings reset to the last
ones used when this interface was open.
•
Enable user compression—this option is enabled only if the scanner and the software allow manual
adjustment of the image compression.
•
Remember compression—when a compression option is available for user adjustment, it cannot be saved as
part of a preset. Select this option to have the compression setting saved.
WIA Driver
•
Use default WIA UI—select this option to display the Microsoft WIA interface instead of the TWAIN
interface in WIA 2.0 applications.
•
Emulate WIA 1.0—select this option to display the TWAIN interface for WIA 1.0 compatible applications.
When this option is selected, WIA 2.0 applications will use the Microsoft WIA interface.
HW IP Settings
The options in this panel are for disabling or enabling the scanner’s hardware image processing (HW IP) options.
Only advanced users should modify any of the options in this section. Options that are not available for your
scanner will be grayed out and disabled.
Click the check box to deselect (disable) hardware image processing only for the option listed. When one of the
options in this window is not selected, software Visioneer Acuity will be used to perform that function while
scanning.
Note: if Visioneer Acuity is not enabled, the function(s) will be disabled in the TWAIN interface until Visioneer Acuity
is turned on or you the select the option in this window.
The options in this window are not available for all scanner models. Please refer to
Checking the Scanner Firmware
Version
and
Checking the Scanner Firmware Version
for information on the options available in hardware for your
scanner.