Xerox Document Centre 240 Install Manual
Page 1
Apple Macintosh (AppleTalk) Network Quick Install Card
Xerox Document Centre 240/255/265 LP/ST
a)
Press the
Connectivity and Network
Setup button.
b)
At the next screen, press the
Network
Setup button.
c)
At the next screen, press the
AppleTalk button.
d)
At the next screen, press the
Protocol
and Media button.
e)
At the next screen, press the
Enable
button to enable the AppleTalk
protocol.
f)
Press
Save.
4.
Assign a Name and Zone to your printer.
a)
You will be returned to the previous
screen. Press the
Name and Zone
button.
b)
At the next screen, press the
Printer
Name button and enter the name you
want for the printer (this is the name
that will appear in the Chooser on your
workstations) using the touch panel
keys. Then press
Save.
c)
You will be returned to the previous
screen. Press the
Zone Name button,
enter the desired text for this item
using the touch panel keys, then press
Save (the printer default is * which
means the printer will appear in ALL
zones).
d)
Press the
Exit Tools button.
Before You Start
If your printer is equipped with a Token Ring
interface, use the
Token Ring Quick Install
Card supplied in this Quick Install Card set to
set the Ring Speed and Source Routing settings
for your environment.
Record the following information
AppleTalk Name ________________________
AppleTalk Zone ________________________
Go to the printer and...
1.
Connect your Document Centre 240/255/
265 to the network with the appropriate
cabling.
2.
Enter the
Tools pathway
a)
Press the
Access ( )button.
b)
On the keypad enter
1111 or the
current password. Press the
Enter
button when finished. If your printer is
an ST model press the
Go to Tools
button, otherwise skip to the next step.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enable the AppleTalk protocol.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769