Xerox DocuPrint C525 A-AP Operation Manual - Message List
20
Message List
If for whatever reason data cannot be sent to the printer when printing, check the messages
displayed in the printer's [Printer State] at [Manage Printers] on the CUPS Web
management site. The following messages (example) are displayed on the computer.
Even if the cause of the problem is the same, the message that is displayed differs
according to how the printer is connected to the Linux computer.
Note
• For details on the messages that are displayed on the printer control panel and how to remedy errors,
refer to the manual provided with the printer.
Possible Problems
Note the following things, which are some things that were discovered while confirming
which operating environments are supported.
• The initial value for the Media Size (paper size) may be Letter, depending on the
distribution.
• Printing may not be done correctly if you are using OpenOffice.org version 1.0.x. Upgrade
your version of OpenOffice.
• If you specify multiple pages/sheet in [Print options page view] in OpenOffice.org or
StarSuite, the multiple pages are not output in the correct layout.
Message (example)
Connection
Method
Condition/Reason/Action
After "Attempting to connect to host xxx.xxx.xxx.xxx
for printer ***" (xxx.xxx.xxx.xxx indicates the IP
address, and *** indicates the printer queue name)
appears "Unable to connect to printer; will retry in 30
seconds...: Connection time out" appears.
Or "Network host xxx.xxx.xxx.xxx is busy, down, or
unreachable; will retry in 30 seconds..." appears.
LPR
The printer's power is off or not connected
correctly. Or, after the computer sent the print
command, the power to the printer was turned
off or it came unconnected before the data was
sent to the printer or while data was been
transmitted (only when using a USB or Parallel
connection). Make sure that the power to the
printer is turned on, and that the cables are
correctly connected.
This message is displayed if for some other
reason the printer cannot receive data. Check if
an error message is not displayed on the
printer's control panel.
"Unable to open USB device***: No such device" (***
indicates the URI for a USB device)
USB
"processing, accepting jobs".
Parallel
"Spooling LPR job, xx% complete..." (xx% indicates
the percentage of the spooling that is complete)
LPR
When LPR connection is used, after the
computer sent the print command, the power to
the printer was turned off or it came
unconnected while the data was being sent to
the printer. Turn on the power to the printer.