Xerox WorkCentre 5019 Network Addendum - page 22
Xerox
®
WorkCentre
®
5019/5021
Network Addendum
22
LPD (connectivity > protocol)
You can set the LPD port.
General
•
LPD Port Status
You can select Enabled to use LPD. (Default: On)
•
Physical Connection
Ethernet is displayed.
•
Port Number
You can set the LPD port No. (a value between 1 and 65535). You must set a unique number for
each port. (Default: 515)
•
Connection Time-Out
You can set the amount of time the machine waits before terminating the connection when
incoming data stops (between 2 and 3600 seconds). (Default: 60)
•
Maximum Connections per Port
The maximum number of connections is displayed.
Apply button
Use to apply changes.
Note
Reboot the machine to enable the new settings.
Port9100 (connectivity > protocol)
You can set Port9100.
General
•
Port9100 Port Status
You can select Enabled to use Port9100. (Default: On)
•
Physical Connection
Ethernet is displayed.
Port information
•
TCP Port Number
You can set the Port9100 port No. (a value between 1 and 65535).
You must set a unique number for each port. (Default: 9100)
•
Maximum Connections per Port
The maximum number of connections is displayed.