Xexun TK-103 User Manual - 12 Gprs Setting
13
◆Power on the tracker outdoor when use the tracker for the first time, it can search the
GPS signal nearby, it also greatly shorten the time of searching the GPS signal for the
future use.
10 Monitoring Mode(voice surveillance mode)
Send SMS monitor+password, the response from the tracker is “monitor ok”
then you can hear the voice around the tracker after your call。
11 Remote Oil&Electricity Cut-off Function
This function is using for the car owner to send a SMS remotely to stop a moving vehicle.
11.1 Setup: Send SMS command powercar123456 00 to the tracker to cut off the oil
and electricity of the car to stop the car.
Reply format: powercar ok. You will receive such a reply if the setting is successful.
11.2 Cancel: Send SMS command powercar123456 11 to the tracker to restart the car
again.
Reply format: powercar ok. You will receive such a reply if the setting is successful.
12 GPRS Setting
In order to use GPRS function, the user needs to set IP, Port and APN ( access point
name ) by either cell phone, or our PC software.
( NOTE:
Some countries or regions should set APN’s User Name and APN’s
Password.)
12.1 Set an IP address and port:
Setup: Send SMS adminip+123456+space+IP address+space+port.
If setup successful, the tracker will reply SMS “adminip ok”