Xexun tk201-2 User Manual - page 10
10
5.10 Movement Alert
This function is using for the owner to get alarm when the unit moves out of a restricted
district.(500m radius).
5.10.1
Setup: When the unit stays immobile in a place for 3-10 minutes, the user can
send SMS move+password to the unit, it will reply “move ok!”. In case of such a
movement, it will send a SMS “Move” along with a Geo-info to the authorized numbers
every 3 minutes, The alert format as below:
lat: 22.566923 long: 114.051331 speed: 0.00 28/10/09 03:33 F:4.32V,0, Signal:F
move imei:359587011016261 05 41.9
5.10.2
Cancel: Send SMS nomove+password to deactivate the movement alert. It will
reply “nomove ok!”.
5.11 Overspeed Alert
This function is using for the owner to control the target’s speed.
5.11.1
Setup: Send SMS speed+password+space+080 to the unit (suppose the speed
is 80km/h), and it will reply “speed ok!”. When the target moves exceeding 80 km/h, the
unit will send a SMS speed+080!+Geo-info to the authorized numbers. It will send such
a SMS again when the speed is low 80 km/h then exceed it within 3 minutes.The alert
format as below:
lat: 22.566923 long: 114.051331 speed:85.60 28/10/09 03:33 F:4.32V,0, Signal:F
speed imei:359587011016261 05 41.9
5.11.2
Cancel: Send SMS nospeed+password to deactivate the overspeed alert.It will
reply “nospeed ok!”.
Remark:
It is recommended that the speed alarm is set at not less than 80km/h. For