Xexun xt107 User Manual - 8.19 Motion Sensor
15
Note:
The SMS message
◆
must in Text format, can’t be PDU format.
◆Please use the tracker outside for the first time so that It can get gps signal easily and quickly
8.18 GSM ID(this function can be add or delect for customization.)
GSM ID are in each sms or gprs data. The tracker can be found by GSM ID without gps signal. But the
customers have to ask their GSM operator for data base of the GSM ID.
8.19 Motion Sensor
This function is for protecting the vehicel or tracker when it is touched.
8.19.1
Setup: Send shake+password+space+1-10 to the tracker to set up this function.(1-10 means
the level of intensity)
8.19.2
Send SMS shake+password+space+1 is the least sensitivity . Have to shake the tracker
strongly to get the alert.
8.19.3
Send SMS shake+password+space+10 is the most sensitivity . Have to shake the tracker
slightly to get the alert
8.19.4
Cancel: Send SMS shake+password+space+0 to remove this function.
8.20 SD card function
A mini SD card can be put in the tracker’s SD card slot. The GPRS data can be saved in the SD card if
GPRS is off. It will send data to the GPRS server again when GPRS is on.
8.20.1
Setup: Send SMS sdlog+password+space+1 to activate the sd card-saving function
Cancel: Send SMS sdlog+password+space+0 to the tracker to deactivate this function
8.20.2
Setup: Send SMS readsd+password+space+1 to ask the tracker to send data in the SD card
to the GPRS server.
Cancel: Send SMS readsd+password+space+0 to ask the tracker to stop sending data in the SD
card to the server.