XFtp XProTec Operation Manual - Initial Setup
XProTec Ultrasonic Distance Meter - Operation Manual
9
Initial Setup
Before taking any measurements with the Ultrasonic Distance Finder,
perform the actions shown in this section.
Before Operation
To install a new battery, perform the following steps;
1. Remove one (1) screw from the battery cover.
2. Remove the battery cover.
3. Connect a standard 9 Volt battery to the unit and replace the cover
and screw.
Backlight Operation
Press the POWER Button to turn on and activate the LCD Backlight for
approximately 7 seconds. Also, pressing any function button will activate
the backlight for a few seconds when the function is performed.
Measurement Units
To select the measurement units press the Ft/M Button. You can select
either Metric (Meters) or Imperial (Feet) measurements.
Measurement Start Point
To select the measurement start point press the Fm/Bm Button. You can
select between either Front of Meter (Fm) or Base of Meter (Bm).