Xilinx Virtex-II Pro ML300 Installation Instructions Manual - Www.Bdtic.Com/xilinx
PN 0402246-01
Page 7 of 17
Solaris
Important Note: The ML300 Evaluation Platform does NOT contain evaluation CDs for this
platform. You must obtain the Solaris version of Foundation ISE separately.
Install CDs
1. Insert the Solaris ISE Disk 1 (not the Windows evaluation version that comes with ML300) into
your CD drive.
2. Change directory to the CD home.
3. Run the setup program.
4. Follow the on-screen directions to complete installation.
5. Insert the Solaris ISE Disk 2 into your CD drive.
6. Change directory to the CD home.
7. Run the setup program.
8. Follow the on-screen directions to complete installation.
Set Environment
•
Within a shell, source the setup script as follows:
source
OR (for Bourne shell users)
source
(Replace
Note: The setup file modifies only the current shell’s environment to run ISE. It must be re-sourced
if you open a new shell.
Apply Service Pack
1. Run the setup executable of the service pack. (The service pack was downloaded during “Step 3:
Download ML300 Reference Design, ISE / EDK Service Packs, and ChipScope Pro Software”.)
2. Follow the on-screen directions to complete installation.
Verify Installation
1. Open a shell and source the ISE environment script as described above.
2. Within the shell, invoke PAR to obtain its usage information:
par
3. Check that the displayed version matches the version you installed. (The first line contains the
release version, e.g. “Release 6.2i”.)