Xilinx Zynq-7000 ZC702 Quick Start Manual - page 3
3
STEP 7:
Set Up Terminal Emulator: Serial Setup
Select the same COM port assigned in Step 5 and set
the
Baud rate
to
115200
, the
Data
to
8 bit
, the
Parity
to
none
,
Stop
to
1 bit
, and
Flow control
to
none
. Click
OK
to save the settings.
X-Ref Target - Figure 1-5
STEP 8:
Initialize Configuration
Press
SW1 (POR_B)
to reinitialize the configuration for
the ZC702 board.
STEP 9:
Terminal Display
After the ZC702 board is configured
in Step 8, text appears in the
terminal emulator window. Type the
number or letter associated with a
listed option to run a test
application. For example, type
2
to
run the LED Test application.
Note:
DIP switches SW15-1 and
SW15-2 are tied in parallel to
pushbuttons SW13 and SW14,
respectively. For SWITCH Test 5,
either use DIP switches SW15-1
and SW15-2, or keep SW15-1 and
SW15-2 OFF and use pushbuttons
13 and 14.
ON
OFF