Xinpu XP-R26DA Handling Instructions Manual - How To Use

HOW TO USE 

CAUTION: 

To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when 

the drill bits and other various parts are installed or removed. The power switch should also be turned off 

during a work break and after work. 

1. Switch operation 

    The rotation speed of the drill bit can be controlled steplessly by varying the amount that the switch is 

pilled. Speed is low when the switch is pulled slightly and increases as the switch is pulled more. 

Continuous operation may be attained by pulling the switch and depressing the 

locked Pushbutton

. To turn 

the switch OFF, pull the switch again to disengage the 

locked Pushbutton

, and release the switch to its 

original position. 

  However, the switch can only be pulled in halfway during reverse and rotates at half the speed of 

forward operation. 

  The switch 

locked Pushbutton

 is unusable during reverse. 

2. Rotation + hammering   

    This rotary hammer can be set to rotation and hammering mode by pressing the push button and turning 

the f

unction knob

 to the 

mark (Fig.4). 

(1) Mount the drill bit. 

(2) Pull the switch after applying the drill bit tip to the drilling position (Fig.5). 

(3) Pushing the rotary hammer forcibly is not necessary at all. Pushing slightly so that drill dust comes out 

gradually is sufficient. 

CAUTION: 

When the drill bit touches construction iron bar, the bit will stop immediately and the rotary hammer 

will react to revolve. Therefore grip the side handle and Main Handle tightly as shown in Fig.5. 

3. Rotation only   

      This rotary hammer can be set to rotation only mode by pressing the push button and turning the 

f

unction knob

 to the 

mark (Fig.6). 

      To drill wood or metal material using the drill chuck and drill chuck shank (optional accessories), 

proceed as follows. 

      Installing drill chuck and drill chuck shank

(Fig.7). 

(1) Attach the drill chuck to the drill chuck shank. 

(2) The part of the SDS-plus shank is the same as the drill bit. Therefore, refer to the item of “Mounting 

the drill bit” for attaching it. 

CAUTION: 

{ Application of force more than necessary will not only expedite the work, but will deteriorate the tip 

edge of the drill bit and reduce the service life of the rotary hammer in addition. 

{ Drill bits may snap off while withdrawing the rotary hammer from the drilled hole. For withdrawing, it 

is important to use a pushing motion. 

{ Do not attempt to drill anchor holes or holes in concrete with the machine set in the rotation only    

function. 

{ Do not attempt to use the rotary hammer in the rotation and hammering function with the drill chuck 

and drill chuck shank attached. This would seriously shorten the service life of every component of the 

machine.